How to Set Up a New Hose Reel Cart
Setting up a hose reel cart takes about half an hour. Assemble the frame, connect the leader hose to the spigot, attach your garden hose to the drum, and wind it evenly — then test for leaks.
Step-by-Step Setup
-
1
Lay everything outUnpack near where the cart will live and check parts against the instructions before you start.
-
2
Assemble the frameFollow the instructions and leave bolts slightly loose until everything is in place, then snug them all down. This keeps the frame square.
-
3
Connect the leader hoseThe short leader hose runs from the spigot to the cart's inlet. Make sure there's a washer in each female end and tighten by hand.
-
4
Attach your garden hoseConnect your hose to the coupling on the drum, again checking the washer.
-
5
Wind it evenlyCrank slowly while guiding the hose side to side so it fills the drum evenly.
-
6
Test for leaksTurn the water on with the nozzle closed. Check every connection; snug or re-washer anything that drips.
How the Water Flows
Water runs from the spigot, through the leader hose, into the cart's inlet, through the swivel at the drum hub, and out through your garden hose.
Every connection is a place a washer has to seal. Hand-tight is enough — overtightening crushes washers and causes leaks.
Caption: take your time on the first wind — an even, tight wrap makes every wind after it easier.
Before You Buy: Check the Size
Make sure the cart is rated for your hose. Capacity ratings are based on 5/8-inch hose, and a little headroom keeps the drum from overfilling. Our sizing guide makes it easy.
Lost a part or need a replacement? Real Hose Storage carries replacement parts for our carts.
4-Wheel Heavy Duty Cart
Powder-coated steel, brass connections, and four no-flat tires — with room for 250 feet of 5/8-inch hose.
Shop the 250 ft CartFAQ: Setting Up a Hose Reel Cart
How do I connect a hose reel cart to the spigot?
Use the short leader hose: one end to the spigot, the other to the cart's inlet. Check that each female end has a washer and tighten by hand.
Why is my new hose reel leaking?
Usually a missing or seated-wrong washer, or a cross-threaded connection. Unscrew it, check the washer, and thread it on again by hand.
How do I wind a new hose onto a reel?
Lay it out straight to remove twists, then crank slowly while guiding it evenly across the drum.
How tight should hose reel connections be?
Hand-tight, plus a little. Pliers crush the washer and can bend fittings.
The Bottom Line
Assemble square, check every washer, wind evenly, and test for leaks. Do it right once and the cart works smoothly for years.
Questions? Call us at (888) 607-4417 or browse our steel hose storage.
We build hose storage that outlives the hose. All steel, no plastic, made for people tired of replacing things.